Home Chapter 1 Parts list
Parts list

The Lessons in this book are focused on the Arduino UNO working with MAX MSP and Jitter though given different pinouts and inputs most Arduino based products will work with the code developed for this book. Pay attention to proper schematics regardless of which microprocessor you are using.

Maxuino will be the new platform running through Standard Firmata.

There is also a short chapter on a web enabled I0-204 IO Bridge used to control things on the world wide web with a work featured by artist Amy Youngs.

I do not recommend the BS2 anymore given the high cost and the more open source nature of the Arduino.

Arduino now has massive amounts of code developed by the open source community, which makes it a superior product.

Additionally, given its open source nature, there are lots of new products all the time and the prices just keep falling.

Arduino UNO (Microcenter has 10$ Arduino Unos R3 though one can often find pre-packaged kits for low $ by searching online.

Component listing:
1pcs UNO R3 Controller Board
1pcs LCD1602 Module ( with pin header)
1pcs Breadboard Expansion Board
1pcs Power Supply Module WARNING: do not use the voltage higher than 9V
1pcs Joystick Module
1pcs IR Receiver
1pcs Servo Motor (SG90)
1pcs Stepper Motor
1pcs ULN2003 Stepper Motor Driver Board
1pcs Ultrasonic Sensor
1pcs DHT11 Temperature and Humidity Module
1pcs 9V Battery with DC
1pcs 65 Jumper Wire
1pcs USB Cable
1pcs Active Buzzer
1pcs Passive Buzzer
1pcs Potentiometer
1pcs 5V Relay
1pcs Breadboard
1pcs Remote
1pcs Tilt Switch
5pcs Button (small)
1pcs 1 digit 7-segment Display
1pcs 4 digit 7-segment Display
5pcs Yellow LED
5pcs Blue LED
5pcs Green LED
5pcs Red LED
1pcs RGB LED
2pcs Photoresistor
1pcs Thermistor
2pcs Diode Rectifier (1N4007)
2pcs NPN Transistor (PN2222)
1pcs IC 74HC595
120pcs Resistor
10pcs Female-to-male Dupont Wire